peugeot 407 key 308 Key Fob Replacement

Peugeot's 308 may be somewhat old-fashioned however it's still eye-catching. It's not the plushest car in its class and it's a Ford Focus or Volkswagen Golf will shield you from imperfections on the road - but it's still a pleasant and civilised driving experience.

We are often asked at Coded Car Keys to replace peugeot key fobs. The following tips can assist whether the issue is ongoing or intermittent.

Water Damage

If you leave your fob in the midst of a puddle or get it wet during kayaking, swimming, canoeing, rafting or canyoning, it's likely to suffer water damage. Keep your key fob in a dry bag every time you are outdoors or engage in activities that expose it to a lot of water.

It's also important to make sure the fob has completely dried before you open it and use it again. If you notice any smells from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's been submerged.

A circuit board that's damp can cause the battery to lose its charge, or even explode. If you can remove the 308 keyfob from the water you need to turn the button side up and shake as much water out as you can before opening the casing. Once you have opened it, remove the battery, and then clean the circuit board using a cotton swab dipped in 90 percent isopropyl alcohol.

Other reasons your Peugeot 308 remote keyless entry system might fail to function include a dead coin battery problems with the receiver module, signal interference, or an electronic chip malfunctioning. If none of these causes the cause, you can try resetting the system by disconnection of the battery that is 12 volts for around 15 minutes.

Dead Coin Battery

peugeot 107 remote key cars come with remote start systems that allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the vehicle before they enter. This feature is very useful particularly in cold winter months. However, there are times when the remote start system stops working due to a variety of reasons, such as the battery in the coin is dead.

A coin-shaped battery located inside the key fob has a life span of two to four years, depending on how often it's used and the location where it was purchased. Its use-by date is typically found on the packaging or written in the manual.

If the key fob has stopped working after exposure to water that is clean then you must remove the battery, then clean the chip with a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it could have fried the chip. You will need to replace it.

If you're not sure whether the battery is in good condition you can check its voltage using an instrument connected to the minus and plus terminals. The voltage should read approximately 12-13 volts however, if it reads lower, the battery needs to be replaced. If you want to, you can try to reset your on-board computer by disconnecting the 12 volt battery for a couple of minutes, and reconnecting it in reverse order (positive cable first followed by negative). The engine should start.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, then it's possible that your receiver module has created a fault. It's the part that sends an alert to the car when the key fob is activated that also acts as an immobiliser. It stops it from starting unless the key that you want to use is present.

This could result from a variety of causes including water damage or simply aging. If the electronic chip within your Peugeot 308 keyfob is damaged by dirty tap water it could be because the keyfob was exposed to it. In this scenario, you'll need to take the device apart and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry you can put the battery back in and test it again.

If the issue persists, it is a good idea to visit a local Peugeot expert or locksmith. They'll make use of a diagnostic device to identify the issue and repair it for you.

Losing your Peugeot car keys can be a stressful experience. A reputable auto locksmith will be able to solve the issue in minutes. They can program your vehicle and cut a fresh, functioning key for you. Click here to find a locksmith in your area.

Faulty Electronic Chip

The chip in the Peugeot 308 key fob plays an essential function in the remote control system. If it is damaged your car might not start, or you could receive a message saying "anti-theft active". In this scenario, the only solution is to replace the key. Auto locksmiths who are professionals are able to offer the service in the shortest time.

The chip in your Peugeot 308 key fob can be damaged due to sweat, water damage dirt, or other causes. If your Peugeot key fob has been exposed to dirty or soapy water, it should be cleaned as soon as possible. You can wipe the electronic component with an absorbent paper towel that has been soaked in isopropyl Alcohol. After that, you should allow the battery to completely dry.

Radio interference can cause a key fob to cease working. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects that are in the vicinity of the vehicle. If you encounter this issue it is recommended to visit an peugeot 3008 key fob dealership.

The peugeot boxer key replacement Key Fob 207/308 is fragile and requires particular care. It is essential not to drop or throw the key fob. If you lose it, try to locate it as quickly as is possible. You can reset the on-board computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative first, and then the positive.