Peugeot 308 Key Fob Replacement

Peugeot's 308 might seem slightly old but it's still appealing. It might not be the plushest car in its class - it's a Ford Focus or Volkswagen Golf will isolate you even better from surface imperfections - but it's a relaxing and a civilized driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is persistent or intermittent these tips will help.

Water Damage

If you accidentally drop your key fob in a puddle, or if it is wet while kayaking, canoeing, rafting, or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry, dry bag each time you go outdoors or do activities that could expose it to excessive water.

It's also essential to make sure that the fob has dried out before you open it up and then use it again. If you detect any smells coming from the fob, like an industrial liquid smell or windshield washer fluid, this is another indication that it's been submerged in water.

A wet circuit could cause the battery's charge to drain or even explode. If you can remove your keyfob 308 from the water it is best to turn the button side up and shake as much water out as you can prior to opening the casing. Remove the battery, then wipe the circuit board down with a cotton swab that has been dipped into 90-percent alcohol.

Other reasons why your Peugeot 308 remote entry keyless system might not function could be due to a dead coin-cell battery or receiver module issues, signal interference or a faulty chip. If none of these are the problem you can restart the system by disconnecting the 12 volt battery from your car for 15 mins.

Dead Coin Battery

peugeot boxer replacement key cars are equipped with a remote-start system which allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to entering. This feature is very beneficial particularly in cold winter months. However, it is possible that the remote start system ceases operating due to a range of reasons, such as an unresponsive coin battery.

The coin-shaped battery located inside the key fob will last between two and four years based on how frequently it is used, where it was purchased, and how it is used. The date of use is printed on the packaging or marked in the user's manual.

If the key fob has stopped working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing. If you expose it to salty or soapy water, the chip may be damaged and you'll require replacing the key fob altogether.

If you're unsure if the battery is faulty you can check its voltage using a multimeter set to your car's voltage range. Connect it to the terminals for minus and plus. The voltage should be around 12-13 volts, however, if it reads lower, the battery needs to be replaced. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should be able to start after this.

Faulty Receiver Module

If you don't see the "Key Detected", it could be that your receiver module is not working properly. It's that part that sends an indication to the car when the key fob is activated, that also acts as an immobiliser and prevents it from starting unless the correct key is used.

This could be due to a range of causes including water damage or simply getting old. If your Peugeot 308 key fob has been exposed dirty tap water, for instance the chip that is located inside the device will be damaged. In this scenario, you'll need to take it out and thoroughly clean it using isopropyl or an electronic cleaner. Once the battery has dried, you can try again.

If the issue is not resolved, it is a good idea to visit the local Peugeot expert or locksmith. They'll be able employ a diagnostic tool help pinpoint the issue and repair it for you.

It is stressful to lose your Peugeot car key. A reputable auto locksmith can solve the issue in a matter of minutes. They can program your vehicle and cut a new working key for you. Click here to find a locksmith near you.

Faulty Electronic Chip

The chip inside the Peugeot 308 key fob is a very important component of the remote control system. If it gets damaged, your car may not start or you might receive a message stating "anti-theft active". If this occurs, the only way to fix the issue is to replace the key. Professional auto locksmiths are able to provide this service in the shortest time.

The chip in the chip of your Peugeot 308 key fob can be damaged due to sweat, water damage dirt, or any other cause. If your peugeot car key cover 308 key fob has been exposed to soapy water, you should clean it right away. You can make use of a paper towel and isopropyl ethanol to clean the electronic component. The battery must then be allowed to completely dry.

Radio interference can cause a key fob to stop working. This can happen when other devices operate on the same frequencies as your Peugeot keyfob. It could also be caused by bad weather or objects in the vicinity. It is recommended that you visit a Peugeot dealer if you encounter this issue.

The peugeot 3008 key programming 207/308 key fob is very delicate and requires a lot of care. It is not recommended to drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset your on-board computer by disconnection of the battery for a few minutes. Disconnect the negative cable before the positive.